77
After installation, you must ac-
tivate the "Speed signal" menu
item in the "Installation" menu
(see p. 78)!
Installing the device
Installing the bracket
Note:
The supplied bracket of the device
is intended for a DIN car sound
system cutout measuring 182 x
53 x 165 mm and an instrument
panel thickness of 1 – 20 mm in
the area of the tabs. For vehi-
cles without DIN tray, you need
a vehicle-specifi c bracket for 50/
52-mm devices. Please contact
your specialised Blaupunkt deal-
er.
Insert the bracket into the tray.
➜
➜
Bend over as many tabs as pos-
sible using a screwdriver.
Insert the device into the tray to
one-third of its length.
Loosen the screw 1 above the
gyroscope 2 on the right side of
the device.
Adjust the gyroscope with a hol-
low hexagon wrench so that the
marking is in the vertical posi-
tion.
➜
➜
➜
➜
A
1
3
5
4
Installation instructions
ROME56E_eng.indd 77ROME56E_eng.indd 77 23.08.2006 15:05:21 Uhr23.08.2006 15:05:21 Uhr
To Next Page
Loading...
