74
Configuration Mode - Complete menu (FULL)
(1)In = nominal drive current
Code Name/Description Adjustment range Factory setting
FUn-
Function menu (continued)
CLI-
Current limitation menu
LC2
• 2
nd
current limitation commutation
nO
nO
L1H
L2H
L3H
L4H
L1L
L2L
L3L
L4L
Assignment
• Function inactive.
• L1H: LI1 active high
• L2H: LI2 active high
• L3H: LI3 active high
• L4H: LI4 active high
• L1L: LI1 active low
• L2L: LI2 active low
• L3L: LI3 active low
• L4L: LI4 active low
If the assigned input is at 0, the first current limitation is active.
If the assigned input is at 1, the second current limitation is active.
See LI assignment information on page 45
CLI
• Current limitation
0.25 to 1.5 In (1) 1.5 In
First current limitation.
CAUTION
RISK OF MOTOR DAMAGE
Check that the motor will withstand this current, particularly in the case of permanent magnet synchronous motors,
which are susceptible to demagnetization.
Failure to follow these instructions can result in equipment damage.
CL2
• Current limitation 2
0.25 to 1.5 In (1) 1.5 In
Second current limitation
This function allows reduction of the drive current limit.
Visible only if 2
nd
current limitation commutation LC2 is not set to nO.
CAUTION
RISK OF MOTOR DAMAGE
Check that the motor will withstand this current, particularly in the case of permanent magnet synchronous motors,
which are susceptible to demagnetization.
Failure to follow these instructions can result in equipment damage.
Parameter that can be modified during operation or when stopped.
I-O-
drC-
CtL-
FUN-
FLt-
COM-
To Next Page
Loading...
