Blizzard Lighting LB HEX Unplugged - Advanced Operating Functions; DMX Configuration and Linking; Color Control and Effects; Dimming and Power Management

Page 13
LB Hex™ Unplugged Manual Rev. A © 2018 Blizzard Lighting, LLC
DMX Channel Mode + Starting Address:
1.) Navigate the main menu until you reach either d13-- (13ch mode),
or d.8-- 8ch mode, and press <ENTER>.
2.) Use the <UP/DOWN> buttons to select a starting DMX address
ranging from 1-512, and press the <ENTER>buttontoconrm.
Master/Slave Mode:
1.)DaisychainxturesDMXinput/outputconnections.
2.)SettheDMXchannelmodeonxturestomatcheitherd.13 or d.8.
3.)TherstxtureintheDMXchainisthemasterxture,andthe
followingxtureswillfollowthemaster.
Manual Color Mixing:
1.) Navigate the top level of the menu to reach either r--- (red), g---
(green), b--- (blue), A--- (amber), P--- (UV), or n--- (white), and then
press the <ENTER> button.
2.) Use the <UP/DOWN> buttons to adjust intensity level anywhere
from 000-255 (0% <--> 100%), and press <ENTER>.
Color Presets:
1.) Navigate the main menu until you reach pr--, and press <ENTER>.
2.) Then use the <UP/DOWN> buttons to select a value ranging from
1-25 (see p. 12), and press <ENTER>.
Strobe Eects:
1.) Navigate the main menu until you reach F---, and press <ENTER>.
2.) Then use the <UP/DOWN> buttons to select a strobe speed setting
from 0-255 (slow <--> fast), and press <ENTER>.
Built-in Programs/Sound Active Mode:
1.) Navigate the main menu until you reach C--- (7-color fade), J---
(7-color jump), or S--- (sound active) and press <ENTER>.
2.) Then use the <UP/DOWN> buttons to select a speed setting from
0-255 (slow <--> fast), and press <ENTER>.
Dimming Curve Settings:
1.) Navigate the main menu until you reach dr--, and press <ENTER>.
2.) Highlight dr-0 to dr-04, and press <ENTER>toconrm.
Power Saving/Temperature Control:
1.) Navigate the main menu until you reach TL--, and press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight TL-0 to TL-02.
3.) TL-0 automatically reduces the LED output to 50% when the internal
temperature reaches 75°C, TL-1 is constant half power, and TL-2 is
constant full power. Press <ENTER>toconrmyourchoice.
4.) Press and hold <ENTER> for 5s to display the current temperature.