Blodgett Mark V Installation

Operation
22
Blodgett IQ2T Control
MANAGER LEVEL PROGRAMMING
Entering the programming mode
1. Press the PROG KEY (10). The top display
reads CodE.
2. Use the product keys to enter the program -
ming access code: 4 5 1 2. Press the ENTER
KEY (14). The top display reads SYS.
Programming hold
Hold allows product to be kept warm in the oven
at a programmed time a nd temperature by press-
ing the HOLD KEY (9).
1. Press the SCAN KEY (15). The top display
reads Hold. Press the TOGGLE/CLEAR KEY
(11) to toggle between YES and no.Pressthe
SCAN KEY (15).
If no is chosen:
a.) Press the SCAN KEY (15) to advance to
programming the setback mode.
Ifyesischosen:
a.) The top display reads HOLD. The bottom
display gives the current hold time. Press
the TOGGLE/CLEAR KEY (11). U se the
product keys to enter a hold time from 0
to 9 hours. Press the SCAN K EY (15) to
enter the new hold time (HR:MN)..
b.) The top display reads HOLD. The bottom
display gives the current hold tempera-
ture. Press the TOGGLE/CLEAR KEY (11).
Use t he product keys to enter a hold tem-
perature from 140_F --- 2 1 0 _F. P r e s s t h e
SCAN KEY (15) to enter the new hold t em-
perature.
c.) The top display reads HFAn. The bottom
display gives the current fan mode. To
change the fan mode press the TOGGLE/
CLEAR KEY (11). The bottom display
toggles between Hi and Lo.Pressthe
SCAN KEY (15) to enter the new fan mode
and continue w ith programming the set-
back mode.
Programming the setback mode
The setback mode operates as a power saving
feature. After a period of non-use (the setback
time) the oven temperature automatically de-
creases to the setback temperature. The oven w ill
maintain this temperature until a product key is
pressed. The minimum setback time is 20:00.
1. The top display reads SEtb. The bottom dis-
play gives the setback mode. To change the
setback press the TOGGLE/CLEAR KEY (11).
The bottom display toggles between YES and
no. Press the SCAN KEY (15).
If no is chosen:
a.) The controller advances to programming
the temperature mode.
Ifyesischosen:
a.) The bottom display gives the current set-
back time. Press the TOGGLE/CLEAR
KEY (11). U se the product keys to the en-
ter the desired setback time. Press the
SCAN KEY (15) to enter the new setback
time.
b.) The bottom display give s the current set-
back temperature. Press the TO GGLE/
CLEAR KEY (11). Use the product keys to
the enter a setback temperature from
140_F --- 3 0 0 _F. P r e s s t h e S C A N K E Y ( 1 5 ) t o
enter the new setback and continue with
programming the temperature mode.
Programming the temperature mode (_ For_C)
1. The top display reads dEg. The bottom dis-
play gives the units. To change the units press
the TOGGLE/CLEAR KEY (11). The bottom
display toggles betw een F and C.
2. Press the SCAN KEY (15) to enter the new
temperature units and continue programming
the shelf sensitivity.

Blodgett Mark V Specifications

General

Model	Mark V
Manufacturer	Blodgett
Category	Oven
Temperature Range	200°F - 500°F (93°C - 260°C)
Construction	Stainless Steel