32
AT6020
Coulter Blades
• 3”-4” Deep (make sure hub is not running in the ground)
• If blades are new or being used for the rst time in a season,
or if residue is hair pinning, sharpening each blade will assist
in cutting during the rst few acres of operation. After the rst
few acres, blades will self-sharpen
Residue Managers – Heavy pressure setting
Shank depth – Minimum 4” deep from ground level (optimum
depth for fertilizer placement is 6”-8”)
Sealer Blade Position – Rear holes on the sealer arm
Sealer Blade Pitch – Blades should be even in pitch and backs of the
blades should be at least 8” apart
Sealer Blade Down Pressure – Down Pressure Kit recommended in
this residue situation
Basket Pressure – Determined by soil type and season in this residue
Wheat &
Other
Small
Grain
Operational Guide For Various Residue Situations
BLU-JET StripTill Implement
Residue Managers
Sealers
Torsion
Basket
Heavy Pressure
Setting
Rear holes
Rear holes
Left-hand
Right-hand
Rear holes
Adjust Sealers
8” apart
Down Pressure Kit
NOTE:
Left-hand
and
right-hand
as viewed
from the rear
To Next Page
Loading...
