JUST POWER ON 09
Warning
The installation should only be performed by qualified professionals
or trained personnel.
All cables should be securely connected and meet appropriate
specifications.
Do not touch the equipment, as the shell may become hot when it’s
running.
Attention
Handle the equipment and accessories with care during loading,
unloading and transportation.
1.2.1 General Requirements
•
Before starting any work, turn off and isolate all electricity to the property at the
main panel.
• Take measures to prevent the electricity from turning back on while working, such
as a safety tag and lockout.
• Test the circuit's voltage before proceeding to verify that the course is off.
• After installing the equipment, remove the idle package materials from the site
such as cartons, foam, plastic, nylon ties, etc.
• Keep people other than the installation technicians away from the energy storage
system.
• When handling equipment and accessories, pack them in their original packaging
or other materials to protect them from impact.
• Seal all the wiring ports with fireproof and water-proof materials to prevent
possible electric shock or other risks.
• It’s prohibited to alter, damage or cover the marking and nameplate of any part of
the system.
• Check and make sure all safe guards, including screws and waterproof rings, are in
place and properly tightened.
• Keep the system firmly secured to the ground or other solid objects, such as a wall
or mounting bracket.
• Use a non-abrasive cloth to clean the equipment and accessories. Do not use water
or harsh chemicals.
• Please follow the instructions to install the EP760 energy storage system.
•
•
•
To Next Page
Loading...
