Boge FOCUS - Page 39

BOGE FOCUS compressor control for piston compressors Page 33
FOCUS 1.9 Fault messages
33
Compressor system pressure transmitter wire
breakage
X
34 Compressor system pressure transmitter faulty X
35 Differential pressure via check valve too high
36 Bus live bit faulty
37 Oil pressure too low X
38 Excessive current compressor motor X
39 Fault compressed air treatment
Parameterizable
(P061)
41 Battery voltage too low
45 Watchdog timer Reset
46 Watchdog not active
48 TAN identifies internal BUS fault X
49 TAN misses data (from basic module) X
57 Temperature compressed air outlet Parameterizable
58 Control unit LEFT key does not open
59 Control unit RIGHT key does not open
60 Basic module recognizes TAN error X
61 Communication with RS485-Module faulty
64 Motor bearing temperature too high (optional) X
73 Parameter type
75
Software version of TAN and basic module not
compatible
76 Suction pressure (booster pressure) too low X
77 Suction (booster) pressure defective X
78 Suction (booster) pressure sensor line break X
79 Operating data memory error
80 Memory error of 2nd operating data memory
81 Parameter memory error X
82 System pressure transmitter faulty
83
Communication with system pressure module defective
Fault no. Meaning Compressor
switch-off