Boge RATIO User Manual

Operating
instructions
RATIO compressor
control for
screw compressors
Before installing or starting the
compressor for the first time, this
manual should be studied carefully to
obtain a clear knowledge of the unit
and of the duties to be performed while
operating and maintaining the unit.
RETAIN THIS MANUAL WITH UNIT.
This technical manual contains
IMPORTANT SAFETY DATA and should
be kept with the air compressor at all
times.

Boge RATIO Specifications

General

Brand	Boge
Model	RATIO
Category	Control Unit
Language	English

Summary

Introduction to the BOGE RATIO Control

The BOGE Control System

Overview of the RATIO control system, its objectives, and microcontroller functions.

Control Panel and Interface

Operating the Compressor

Compressor Operation Modes

Procedures for switching on, run-up, load, standby, and switch-off operations.

Maintenance and Servicing Intervals

Pressure and Software Settings

Configuration of target network pressures and display of software version information.

Frequency Converter Parameterization

Specific steps for parameterizing the frequency converter when the motor is stopped.

Control Parameterization

Error Key Table

Reference list of error codes, their meanings, and required compressor cut-out actions.

General Parameterization Procedures

Advanced Parameter Settings

External Controls and Communication

Remote and Network Communication Setup

Auto-Restart and Idling Control

Configuring auto-restart after power failure and idling control for short operation cycles.