Index
BOGE – RATIO compressor control for screw compressors
Inhalt.pm6.5 - USA
Page III
Index
1.1 The BOGE control ........................................................................1.1
General .......................................................................................... 1.1
Microcontroller................................................................................ 1.1
1.2 The BOGE control concept ......................................................... 1.2
Operating and control panel ........................................................... 1.2
1.3 Operating elements ...................................................................... 1.3
1.4 Operation ...................................................................................... 1.6
Parameterization of frequency converter without running motor ..1.11
1.5 Control Parameterization ........................................................... 1.12
Error key table .............................................................................. 1.12
General ........................................................................................ 1.13
Parameterization ..........................................................................1.13
Enter Parameterization Code .......................................................1.13
Set the compressor servicing interval and restart ........................1.13
Set the motor servicing interval and restart.................................. 1.14
Set load cycles dependent servicing / inspection and restart .......1.14
Change target pressure values (P
max
and P
min
) ............................. 1.14
External output enable .................................................................1.15
Proportional control ......................................................................1.16
Timer ............................................................................................1.16
Switching
Local-Remote
via key switch ........................................ 1.16
Remote On-Off control .................................................................1.17
Enable network independent ON-OFF memory (Auto-Restart).... 1.18
Idling control for extremely short operating times
(Change after-running time) .........................................................1.18
Set continuous mode ...................................................................1.19
Anti freeze operation (only in mode
ready for operation
) .............. 1.19
RS 485-Bus-Address ...................................................................1.20
Parameter overview...................................................................... 1.20
1.6 Faults – General ......................................................................... 1.21
Automatic monitoring of the control systems ................................ 1.21
1.7 Fault messages of the control system ..................................... 1.22
Fault ............................................................................................. 1.22
Acknowledge messages ............................................................... 1.22
1.8 Warning messages of the control .............................................1.25
Part 1:
RATIO
To Next Page
Loading...
