Bosch ADS?AMC2?2WCF - Ethernet Host Interface

26 en | Installing
Access Modular
Controller 2
2019-11 | V02 | Bosch Security Systems B.V.
4.8 Ethernet Host Interface
The controller offers a 10/100 Mbit/s Ethernet auto-sensing
interface to connect to a local area network or host computer.
Notice!
Use a CAT5 or higher version to connect the controller with the
network.
Figure4.8: Location of the Ethernet interface
Notice!
After connecting a new controller to a network using DHCP, it
can take some time before the new controller is recognized by
the remote server.
You can accelerate this process by running the following
command:
ipconfig /flushdns
This makes the controller immediately available by its name.