Access Modular
Controller 2
Operating | en 29
Bosch Security Systems B.V. 2019-11 | V02 |
5 Operating
5.1 Configuring Ethernet interface
To configure the controller in a TCP/IP network environment,
use the AmcIpConfig tool. It is located in a directory on the
standalone or the remote server of the BIS:
\\Runtime-drive:\MgtS\AccessEngine\AC\bin
and in the Program Folder of the Access PE:
Start > Programs > Access Personal Edition > AmcIpConfig
This tool can be copied and used on every computer on the
network.
Consult the online help of the AmcIpConfig for details on
configuring the controller.
To ensure that the controller can communicate with the
software follow these naming rules:
– Use only alphanumeric characters plus the seperator
"-" (minus/dash).
– Do not use special characters or spaces.
– The network name must start with a letter.
– The names are not case sensitive.
To Next Page
Loading...
