Bosch ADS?AMC2?2WCF - System Overview

Access Modular
Controller 2
Introduction | en 15
Bosch Security Systems B.V. 2019-11 | V02 |
3.3 System overview
The controller is connected to the host system via RS485 or
Ethernet, depending on the type of installation. The host
interface is selected during installation. The two interfaces are
available on the device by default. With RS485 operation, a
maximum of eight access controllers can be connected to one
party line.
2
3
3
2
1
2 2
3
3
4 4
1 Host computer
2 Access Modular Controller
3 Card reader
4 Communication and power supply
In the communication chain of a system, the access controller is
integrated between the host system and the peripheral devices.
It is possible to connect up to two readers to the access
modular controller.