Bosch ADS?AMC2?2WCF - Page 31

Access Modular
Controller 2
Troubleshooting | en 31
Bosch Security Systems B.V. 2019-11 | V02 |
Problem Cause Solution
– Set DIL switch
5 to ON (SDEB
protocol is
selected).
Controller does not
work as expected.
– Switch the
power of the
controller off
and on again.
– Check the
configuration
of the
controller.
If necessary,
delete all
configuration
data by
Resetting the
Device to
Factory
Default.
– Reset the
controller as
described in
Resetting the
software, page
32.