The system displays the next menu item: ZONE IN AREA. There is no need to proceed to
the following menu items for deleting a zone.
9. Press [–] four times to get to the EXIT PROG. +SAVE menu.
10. Press [#] to save the data end exit the programming mode.
P The selected zone is deleted (example: zone 1 is deleted).
Enabling the RF Receiver for Wireless Communication
1. Enter the installer code [1234] + [958] and press [#].
2. Select 7 RF MANAGER and press [#].
3. Select RF SETTING and press [#].
4. Select RF RECEIVER and press [#].
5. Select 1-enable and press [#].
6. Press [#] to confirm.
7. Press [–] three times to get to the EXIT PROG. +SAVE menu.
8. Press [#] to save the data end exit the programming mode.
P The RF receiver for wireless communication is enabled.
Setting up a Zone for an RF Device
1. Enter the installer code [1234] + [958] and press [#].
2. Select 3 ZONE MANAGER and press [#].
3. Select ADD/DELETE ZONES and press [#].
The system displays the next menu item: INPUT ZONE No.
4. Enter the number of the zone to which you to assign the RF device and press [#].
The system displays the next menu item: ZONE NAME INPUT.
5. Optionally enter a name for the zone. Therefore, the numbers on the text keypad function
as an alphabetical input.
6. Press [#] to confirm.
The system displays the next menu item: ZONE MODULE SEL.
7. Select the correct zone module depending on the RF device:
For RFUN / RF3401E (Zone input only) select 5-RF RFUN no magn
For RFGB / RF1100E (Glass Break Detector) select 4-RF RFGB glassb.
For all other RF devices (Zone input only) select 3-RF all
8. Press [#] to select and [#] again to confirm.
The system displays the next menu item: ZONE FUNCTION.
9. Enter 01 for the zone function 01-instant and press [#].
The system displays the next menu item: ZONE IN AREA.
10. Enter the number of the area you want to assign to this zone and press [#].
The system displays the next menu item: ZONE RFID: MANUAL.
11. Enter the RF ID manually (9 digits).
Or
Press and hold [*] for three seconds to switch to the ZONE RFID: AUTO menu.
Trigger the RF device to give alarm once.
The RF ID will be entered automatically.
12. Press [#] to confirm.
13. Press [–] four times to get to the EXIT PROG. +SAVE menu.
14. Press [#] to save the data end exit the programming mode.
P The selected zone is set up for an RF device.
5.4.3
5.4.4
12 en | Programming and Operating the AMAX System AMAX 2100 / 3000 / 4000
2014.11 | 02 | F.01U.309.297 Quick Start Manual Bosch Sicherheitsysteme GmbH
To Next Page
Loading...
