Bosch AUTODOME 7000 VG5-7230 - Page 28

Fuse Specifications
Volts XF101 Mains XF102 Camera XF103 Heater
24 V T 5.0 A T 2.0 A T 3.15 A
115 V T 1.6 A T 2.0 A T 3.15 A
230 V T 0.8A T 2.0 A T 3.15 A
!
Warning!
Fuse replacement by qualified service personnel only. Replace with same type fuse.
Fuse Specifications
Volts XF101 Mains XF102 Camera XF103 Heater
24 V T 5.0 A T 2.0 A T 3.15 A
115 V T 1.6 A T 2.0 A T 3.15 A
230 V T 0.8A T 2.0 A T 3.15 A
The following table lists the Power Supply Box connectors:
No. Connector Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6
Ground Grounding Screw
P101 115/230 VAC or
24 VAC Power In
Line NC Neutral
P106 SERIAL
COMMUNICATIONS
CODE-
(Audio IN-,
Audio in
signal
ground)
CODE+
(Audio IN+)
Earth GND
(Ground)
(Audio)
RXD
(Audio OUT+)
TXD
(Audio OUT-;
Audio out
signal
ground)
Signal
GND
(Ground)
P107 24 VAC Power
(Arm Harness)
Camera
24 VAC
Camera
24 VAC
Earth
Ground
Heater
(24 VAC)
Heater
(24 VAC)
Table 8.1: Power Supply Box Connections
Notice!
Pins for P106 1, 2, 4, and 5 are used for audio input and output for AUTODOME 7000 Series
cameras; however, their labels are still those of previous versions of analog AUTODOME
cameras.
28 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts AUTODOME 7000
2014.04 | 2.0 | F.01U.283.679 Operation Manual Bosch Security Systems, Inc.