Figure 9.2: VG4-A-PSU1 or VG4-A-PSU2 Power Supply Box Connected to Pipe Interface Board
VG4-A-PSU1/VG4-A-PSU2 Pipe Interface Board
1 120 VAC/230 VAC Power In 7 P101 Connector
2 P101 Connector 8 P107 Connector
3 Ground Connection 9 24 VAC Power In (to camera)
4 Transformer 10 Earth Ground
5 24 VAC Power Out 11 24 VAC Power In (to camera)
6 P107 Connector 12 24 VAC Power In (to Heater)
13 24 VAC Power In (to Heater)
14 Camera Power
15 Heater Power
Wiring the Power Supply Box
Notice!
Refer to the Connection, page 71 chapter for wire specifications and distances.
4 Route the high voltage 115/230 VAC lines through the earth-grounded conduit fitting on
the left side of the box.
Notice!
The Power Supply Box with transformer comes with a barrier that separates the high voltage
side on the left from the low voltage 24 VAC side on the right.
AUTODOME 7000 Installing the Roof Parapet and Pipe Mounts | en 43
Bosch Security Systems, Inc. Operation Manual 2014.04 | 2.0 | F.01U.283.679
To Next Page
Loading...
