Bosch AUTODOME 7000 VG5-7230 - Page 63

P105
P104
P102
P103
J101
J102 24VAC 24VAC
P101
SIG GND TXD (-) RXD (+) C + C -
NC NO COM AGND A2
A1
J103
A3 A4 A5 A6 A7 AGND AGND OUT3 OUT2 OUT1
Figure 10.7: In-ceiling Interface Box
1
Fiber Optics 5 Coax Video
[Not applicable for AUTODOME
7000 Series cameras.]
2 Ethernet Video 6 Alarm In
3 Dome Power 7 Analog In
4 Data In/Out 8 Relay
The following table summarizes the pin connectors and their function:
No.
Connector Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6 Pin 7
P103 Alarms In Alarm 3 Alarm 4 Alarm 5 Alarm 6 Alarm 7 AGND
P102 Alarms Out Alarm 1 Alarm 2 Alarm 3 GND
P104 Analog Relay Relay N.O. Relay
COM
Relay N.C. Earth Alarm 1 Alarm 2 Ground
P101 24 VAC Line Earth Neutral
P105 SERIAL
COMMUNI-
CATIONS
CODE-
(Audio IN-,
Audio in
signal
ground)
CODE+
(Audio IN+)
Earth GND
(Ground)
(Audio)
RXD
(Audio OUT+)
TXD
(Audio
OUT-;
Audio out
signal
ground)
Signal
GND
(Ground)
J101 Ethernet Connector Input
Table 10.1: Interface Box Wire Terminals
AUTODOME 7000 Installing the In-Ceiling Mount | en 63
Bosch Security Systems, Inc. Operation Manual 2014.04 | 2.0 | F.01U.283.679