Caution!
The camera disables the Privacy Mask function if the orientation is set to Inverted.
SC settings
Click the Default button to restore all camera settings to their original defaults.
SC data
Click the Default button to clear all prepositions, privacy masks, and other configuration
settings defined in the camera’s web server to their default values.
Reboot device
Click the Reboot button to reboot the camera. There is a ten (10) second pause before the
dome starts its homing phase. During the homing phase, the camera pans left and right and
tilts up and down. It also adjusts the lens focus. The entire homing phase lasts approximately
40 seconds.
Factory defaults
Click the Defaults button to restore the configuration settings defined in the camera’s web
server to their default values. A confirmation screen appears. Allow 5 seconds for the camera
to optimize the picture after a mode reset.
AUTODOME 7000 Configuration via IP, Advanced Mode | en 95
Bosch Security Systems, Inc. Operation Manual 2014.04 | 2.0 | F.01U.283.679
To Next Page
Loading...
