11
Installation instructions
The following installation instructions describe the
installation steps for various appliance types.
Therefore the diagrams may be a general representation
of your appliance.
Particular reference is made to special installation steps
for individual appliance types.
1. Checking the installation enclosure
, CAUTION:
Use the following check list for a safe and trouble
free installation.
1. Check the floor.
See section on “Installation/Floor”.
2. Check the dimensions of the installation enclosure,
see “Installation dimensions”.
3. Check that the installation enclosure is square.
4. Check location of the socket.
See section on “Connecting the power” and in the
section on “Installation dimensions”.
5. Check location of the water connection
(only for appliances with ice maker).
See section on “Connecting the water” and in the
section on “Installation dimensions”.
6. Check attachment of the adjacent cabinet/fixtures.
All cabinet parts in the vicinity of the appliance must
be connected securely to the wall.
7. Check that adjacent cabinet/fixtures have adequate
clearance (door opening angle).
2. Removing the packaging
, WARNING:
Be careful, otherwise people who are helping may
be injured or the appliance may be damaged!
The appliance may tip over while it is being
unpacked or if the doors are opened.
The appliance is very heavy.
Note:
Check appliance for damage in transit.
Do not install the appliance if it is visibly damaged.
If in doubt, contact your dealer.
To avoid floor damage:
1. Remove the packaging carton and be careful not to
damage the surface of appliance.
2. Place packaging cardboard or plywood under the
appliance.
3. Remove accessories from the outside
of the appliance.
Keep adhesive tape which was used to attach
the supplied accessories to the appliance.
It can be used subsequently for attaching an edge
protection to the installation cavity walls (see section
on “A / 3. Attaching an edge protection”).
4. Remove transportation protection devices (a) and lift
appliance off the pallet – appliance is very heavy!
5. Carefully open the appliance – risk of tipping over –
and remove accessories and installation materials
from inside the appliance. Close the door again.
Note:
Do not remove transportation safety devices which
protect the shelves and storage compartments
inside the appliance until the installation is complete,
otherwise the parts may be damaged.
To Next Page
Loading...
Need help?
General
