23
11. Attaching the door panel
(refrigerator compartment)
Note:
Now attach the furniture handles which are screwed from
behind!
1. Remove the fixing brackets (a) from the appliance
door. To do this, loosen the bracket screws (b) only.
2. Insert removed fixing brackets (a) into the adjusting
rails (b) on the door panel.
3. Open the appliance door.
4. Hang the door panel with adjusting rail over the
double threaded bolts (1.).
5. Lower door panel and push the fixing brackets down
over the bracket screws (2.).
6. Adjust the door panel using the double threaded
bolts (Torx screwdriver). Re-examine the
dimensions of the gap continuously.
7. Close the door and check that the depth of the door
panel is aligned with the adjacent fronts.
If required, correct.
8. Tighten the bracket screws to fix the depth
alignment.
9. Close the door and check the side alignment.
Correct by gently tapping the edge of the open door
panel with your hand.
To Next Page
Loading...
Need help?
General
