24
10. Screw nuts onto the double threaded bolts and
tighten. This will fix the side alignment of the door.
12. Attaching the door panel
(freezer compartment)
Note:
Now attach the furniture handles which are screwed from
behind!
1. Remove the fixing brackets (a) from the drawer.
To do this, loosen the bracket screws (b) only.
2. Insert removed fixing brackets (a) into the adjusting
rails (b) on the door panel.
3. Open the drawer.
4. Hang the door panel with adjusting rail over the
double threaded bolts (1.).
5. Lower furniture door and push the fixing brackets
down over the fastening screws (2.).
6. Adjust the door panel using the double threaded
bolts (Torx screwdriver). Re-examine the
dimensions of the gap continuously.
7. Close the door and check that the depth of the door
panel is aligned with the adjacent fronts.
If required, correct.
8. Tighten the bracket screws to fix the depth
alignment.
9. Close the door and check the side alignment.
Correct by gently tapping the edge of the open door
panel with your hand.
To Next Page
Loading...
Need help?
General
