EasyManua.ls Logo

Bosch B5512 - Cellular Menu; IP Camera

Bosch B5512
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
B93x/B94x keypads use of Connection (for the Bus Module)
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [2] Network > (choose the bus module or on-board) > [2] Connection. The keypad
scrolls through the following sub-categories, indicating the diagnostic information for:
Link, IP Address, DNS, WAN IPv4, WAN IPv6, LAN IPv4, LAN IPv6.
3. When finished viewing the information, escape from the menu.
[3] Cellular menu
You can obtain certain cellular module diagnostic information using a keypad and this menu.
Cellular (diagnostics)
B91x/B92x keypads use of Cellular (diagnostics)
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [3] Diags Menu > [3] Cellular > (choose the SDI2 cellular module or plug-in
module). The keypad scrolls through the following sub-categories, indicating the
diagnostic information for:
– Link (Yes or No. Yes indicates a data connection to the carrier. No indicates a
connection problem.)
– iPv4 IP (The IP address of the cellular radio on the carrier’s network.)
– Base ID
– Signal (Signal strength = unacceptable, marginal, good, or very good.)
– Signal (In dBs.)
– Tel Num (If provided by the carrier.)
– ESN (The cellular radio electronic serial number.)
– Model (The cellular radio model.)
– Version (The cellular radio version.)
3. When finished viewing the information, escape from the menu.
B93x/B94x keypads use of Cellular (diagnostics)
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [3] Diags Menu > [3] Cellular > (choose the SDI2 cellular module or plug-in
module). The keypad scrolls through the following sub-categories, indicating the
diagnostic information for:
– Link (Yes or No. Yes indicates a data connection to the carrier. No indicates a
connection problem.)
– iPv4 IP (The IP address of the cellular radio on the carrier’s network.)
– Base ID
– Signal (Signal strength = unacceptable, marginal, good, or very good.)
– Signal (In dBs.)
– Tel Num (If provided by the carrier.)
– ESN (The cellular radio electronic serial number.)
– Model (The cellular radio model.)
– Version (The cellular radio version.)
3. When finished viewing the information, escape from the menu.
[4] IP Camera
IP Camera
19.3.3
19.3.4
140 en | Keypad Installer menu Control Panel
2015.07 | 12 | F.01U.287.180 Installation and System Reference Guide Bosch Security Systems, Inc.

Table of Contents

Other manuals for Bosch B5512

Related product manuals