Bosch B5512 - Control Panel Board Overview

Control panel board overview
3
1
2
TMPR
1 COM 2 7 COM 83 COM 4 5 COM 6
RESET
ETHERNET
COM AUX R Y G B
PWR A B COM
+ BAT - 18VAC
B C
OUTPUT
X
MODULE 1
Y
MODULE
RELEASE
NO C NC
OUTPUT A
7 COM 8
C
OUTPUT
B
USB
ETHERNET
100BASE-T
LINK
COMMUNICATION MODULE 1
1 k End of Line Resistors
Voltage Ranges
ON-BOARD POINTS
3.7 - 5.0 VDC
2.0 - 3.0 VDC
0.0 - 1.3 VDC
Open
Normal
Short
3 COM 4 5 COM 61 COM 2
R Y G B
SDI2
Device Bus
18 VAC
BATTERY OUTPUT A
AUX
- 12 V +
OUTPUT A
OUTPUT A
Jumper Under Cover
AUX PWR
COM
DRY
4
8
9
7
13
14
12
11
10
5 6
20 19
17
16 1518
Figure 16.1: Control panel board overview (B5512 shown)
Callout ᅳ Description For more information, refer to:
1 ᅳ Jumper to configure OUTPUT A Configure OUTPUT A using the jumper, page 25
2 ᅳ OUTPUT A LED
3 ᅳ Holes to stabilize plug-in modules Installation and module wiring (B430), page 35 or
Installation and module wiring (B44x), page 41
4 ᅳ Plug-in module connector
5 ᅳ Green 100BASE-T LED On-board Ethernet diagnostic LEDs, page 40
6 ᅳ Yellow LINK LED
7 ᅳ Plug-in module retention clip Installation and module wiring (B430), page 35 or
Installation and module wiring (B44x), page 41
8 ᅳ On-board Ethernet connector On-board Ethernet connection, page 39
9 ᅳ USB connector Programming, page 21
10 ᅳ Heartbeat LED (blue) Installer keypads and SERVICE MODE, page 101
11 ᅳ RESET button
12 ᅳ Terminals for Output B and Output C Open collector outputs, page 59
16
Control Panel Control panel board overview | en 77
Bosch Security Systems, Inc. Installation and System Reference Guide 2015.07 | 12 | F.01U.287.180