a)
b)
c)
d)
e) f) g) h) i)
a) Change signal device, if desired.
b) Change signal channel, if desired.
c) Choose signal threshold. See chapter 'Electrical trigger signal' for details.
d) Define threshold of input channel signal when trigger is released.
Only possible, if no digital source is selected as signal source.
e) Define presettings for trigger. See chapter 'Lap trigger presettings' for details.
f) Define condition settings; change signal for vehicle speed, define speed settings.
See chapter 'Distance based retrigger protection' and 'Distance based forced trigger' for details.
g) Define settings for main trigger. See chapter 'Lap timing' for details.
h) Define settings for counddown timer. See chapter 'Countdown timer' for details.
i) Define settings for sub trigger. See chapter 'Segment timing' for details.
j) Define settings for a GPS lap trigger. See chapter 'GPS lap trigger' for details. Only applicable
if the signal source is set to 'GPS lap trigger'.
j)
Preset values for lap counter
and outing counter
Minimum laptime that a new
'best laptime' is accepted
Preset value for 'best laptime'
Change signal for vehicle speed,
if desired.
Enter minimum speed for
trigger release.
Define settings for distance
based retrigger protection.
Define settings for distance
based forced trigger.
To Next Page
Loading...
