6-9
Climate Class 6100i / 6000i / 8100i / 8000i
13) Unscrew the nut, take out the Propeller
Fan carefully.
14) Remove all screws, take out the Motor.
Control Unit
1) Cut the Fixing Band.
2) Remove the screw, then remove the
Terminal Board.
3) Lift up to remove the metal cover.
4) Remove the screw fixing the earth wire.
5) Move out the Heat Sink Holder.
6) Unscrew all four screws to remove the
Control Board Unit.
Note: Before changing control board, the
workmen should wear anti-eletrostatic gloves.
To Next Page
Loading...
