Operation
Climate Class 6100i/8100i – 6721831492 (2021/02)
16
3.7 Setting main operating mode
At outside temperatures below 18 °C cooling is not possible to protect
the outdoor unit.
If the outside temperature is very low, the heating capacity of the air
conditioning system may not be sufficient. We recommend connecting
additional heat sources.
Using cooling or heating mode
▶ Press the button (cooling mode) or the button (heating mode)
to turn the appliance on.
The green operation lamp K lights up.
▶ Press the Temp. button to set the desired temperature between 16
and 30 °C.
Using automatic mode
▶ Press the Auto button (automatic mode) to turn the appliance on.
The green operation lamp K lights up.
Automatic mode chooses cooling or heating depending on outside
temperature and room temperature.
C Turning on auto mode selects cooling
H Turning on auto mode selects heating
T
out
Outside temperature
T
room
Room temperature
T
S
Automatically set temperature in °C
Automatic mode does not switch between cooling or heating. Only the
set temperature changes automatically.
▶ Press the Auto button twice, to revaluate this automatic setting.
▶ Press the Temp. button to set an offset of up to 2 °C for the
automatically set temperature.
The indoor unit switches on/off automatically to hold the set
temperature.
Examples for the offset in automatic mode:
Table 7
Set fan speed
▶ Press the Fan button to set the desired fan speed.
[1] Auto
[2] Quiet
[3] Soft
[4] Low
[5] High
The fan speed cannot be adjusted in automatic mode or
dehumidification mode.
Switching the appliance off
▶ Press the Stop button.
The green operation lamp K turns off.
3.8 Plasmacluster mode
Plasmacluster ions released into the room are effective against airborne
contaminants, such as mold, viruses, and allergens.
▶ During operation, press button.
The remote control displays .
The blue plasmacluster lamp on the unit lights up.
To cancel:
▶ Press button again.
The blue plasmacluster lamp on the unit turns off.
NOTICE
▶ Use of the plasmacluster mode will be memorized, and it will be
activated the next time you turn on the air conditioner.
▶ To perform the plasmacluster mode with fan only mode, press the
plasmacluster button while the unit is not operating. The operation
mode symbol at the top left on the remote control will disappear and
the fan speed can not be set to auto.
3.9 Full power mode
In this operation mode, the air conditioner works at the maximum power
to rapidly heat or cool the room.
▶ During operation, press the button.
The remote control displays and the temperature disappears.
To cancel full power mode:
▶ Press the button again.
The unit returns to its original settings.
Full power mode will automatically cancel after one hour.
You can not set the temperature or fan speed during full power mode.
Switch-off temperature is 1°C higher
Switch-off temperature is 2°C lower
0010037112-001
T
room
/ °C
T
out
/ °C
H
C
21 21
0
T
S
24
T
S
23
T
S
22
T
S
24
T
S
25
T
S
26
10 18 28 34
0010035985-001
1
2
3
4
5
OBJ_DCL-6721831492-001.fm Page 16 Friday, April 23, 2021 9:45 AM
To Next Page
Loading...
