Appendix
35
Compress Hybrid 7000i AW – 6721833053 (2020/09)
12.4 System commissioning report
Commissioning date:
Customer address: Last name, first name:
Postal address:
Town:
Telephone number:
Installation company: Last name, first name:
Street:
Town:
Telephone number:
Product information: Product type:
TTNR:
Serial number:
FD-no.:
System components: Receipt/value
Room control Yes | No
Room temperature-dependent control unit with humidity sensor Yes | No
Solar integration Yes | No
Buffer cylinder Yes | No
Type/Volume (l):
Domestic Hot Water Tank Yes | No
Type/Volume (l):
Other components Yes | No
Which?
Minimum clearances of the outdoor unit:
Is the outdoor unit on a solid, flat surface? Yes | No
Is the outdoor unit securely anchored? Yes | No
Is the outdoor unit standing in a location where snow cannot slide off the roof
onto it?
Yes | No
Minimum wall clearance? ...............mm
Minimum clearances at sides? ...............mm
Minimum distance to roof? ...............mm
Minimum distance in front of the outdoor unit? ...............mm
Outdoor unit condensate hose
Does the condensate hose have a heating cable? Yes | No
Connections on the outdoor unit
Were the connections established correctly? Yes | No
Who installed/prepared the connecting pipework?
Minimum clearances, indoor unit:
Minimum wall clearance? ...............mm
Minimum distance in front of the unit? ...............mm
Heating:
Pressure determined in the expansion vessel? …….. bar
The heating system has been filled according to the pressure determined in the expansion vessel to ...... bar
Has the heating system been flushed before installation? Yes | No
Has the particle filter been cleaned? Yes | No
Electric connection:
Were the low voltage cables installed with a minimum distance of 100 mm
from 230 V/400 V cables?
Yes | No
Were the CAN-BUS connections established as specified in the instructions? Yes | No
Has a power guard been connected? Yes | No
Is the outside temperature sensor T1 on the coldest side of the house? Yes | No
To Next Page
Loading...
