Installation
9
Compress Hybrid 7000i AW – 6721833053 (2020/09)
5 Installation
5.1 Transport and storage
The indoor unit must always be transported in its packaging and stored
in an upright position. The indoor unit can be provisionally tilted for
transportation purposes if required.
After unpacking the indoor unit, do not place or set it down on the pipes
or on the side panel.
▶ After unpacking the indoor unit, lay it down on the back panel.
Do not store or transport the indoor unit at temperatures below – 10 °C.
5.2 Unpacking
▶ Remove the packaging according to the instructions on the packaging.
▶ Take out enclosed accessories.
▶ Check that all package contents are present.
5.3 Indoor unit installation
5.3.1 Removing the cover
To unlock the cover [1]:
▶ Unscrew the retained unlocking screw [2] on the underside of the
indoor unit using a suitable tool.
Fig. 11 Unlock the cover
[1] Cover of the indoor unit
[2] Unlocking screw
To detach the cover [2] from the bottom fixing [1]:
▶ Pull the cover [2] on the underside slightly forwards.
Fig. 12 Detach the cover from the bottom fixing
[1] Fixing on the underside
[2] Cover of the indoor unit
To detach the cover [2] from the top fixing [1]:
▶ Push the cover [2] slightly up.
Fig. 13 Detach the cover from the top fixing
[1] Fixing on the top side
[2] Cover of the indoor unit
To Next Page
Loading...
