Bosch Control 8310 - Commissioning; Notices on Commissioning; Commissioning Wizard

Commissioning
11
Control 8310 – 6720856493 (2022/07)
9 Commissioning
▶ Complete and sign commissioning report during commissioning and
conclusion of the commissioning ( chapter 17.2, page 18).
9.1 Notices on commissioning
Before commissioning, the control unit must be set at the system:
▶ Set parameter ( Chapter 10, page 12) according to the heat
source and system.
▶ Ensure that the heat is absorbed (e.g. by the DHW heating).
Otherwise the heat source will switch off.
9.2 Commissioning wizard
A Commissioning wizard is available for making the initial settings after
switching on the control unit for the first time.
The most important settings for operation of the control are made here.
Fig. 8 Commissioning wizard
[1] Commissioning wizard
[2] Deutsch
[3] Europe/Berlin (Select time zone)
[4] Cancel
[5] Save
[6] Date
[7] Date format
[8] Time
[9] Time zone
[10] Language
After tapping a field, a selection for this menu item opens.
For every selection box:
▶Perform setting.
▶Tap on Save or Cancel.
Tap on Save to apply the settings and close the assistant.
If the Commissioning wizard is not run or is cancelled, the settings in
the corresponding menus may be changed.
0010025761-002
XX:XX
XX.XX.XXXX
XX.XX.XXXX
Europa/Berlin
DeutschSprache
Zeitzone
Uhrzeit
Datumsformat
Datum
Inbetriebnahme Assistent
Speichern Abbrechen
1
2
3
4
8
10
9
7
6
5