Bosch D6412 - DX3010 Address Programming

D6412/D4412 Operation and Installation Guide
Page 44 © 2003 Bosch Security Systems45349E
D6412/D4412
Off-Board Outputs
10.2.6 Address Programming
Each DX3010 Module connected to the panel must have its address jumpers set to the address shown in Table 14.
Panel Output # SDI Address
D6412/D4412 5 to 12 SDI Address 150
D6412 only 13 to 20 SDI Address 151
Table 14: DX3010 Address Settings
Any time the address jumpers are changed, you must cycle the control panel power OFF and then ON for the changes to
take effect. Set the address jumpers as shown in the Table 15. “DN” indicates that the DIP switch is CLOSED (Down). See
Figure 30 for DIP Switch configuration.
Panel SDI
Address
DIP Switch, X = DIP Switch is CLOSED
1 2 4 8 16 Mode
D6412/D4412 150 UP UP UP UP UP
DN
D6412 only 13 to 20
DN
UP UP UP UP
DN
Table 15: DX3010 Address Jumper Settings
=Switch CLOSED (Down
)
=Switch OPEN (Up)
Example:
Module Address 150
OPEN
123456
Figure 30: DX3010 Address DIP Switches