D6412/D4412 Operation and Installation Guide
D6412/D4412
Page 55© 2003 Bosch Security Systems 45349E
Installer’s Keypad and Installer Mode
13.3.6 Press [6] for Output Test
When you press [6] for Output test, the display shows Output1, Hold [*] for ON. Press and hold the [*] key to
turn output on. Press the [*] key (without holding) to end current output test and to advance to next output. Press [Cmd]
to return to the Installer’s Menu.
13.3.7 Press [7] for RF Menu
Pressing [7] moves the system into the RF Menu. This menu consists of three scrolling choices that allow you to add RF ID
codes, test RF devices, and view or remove RF ID codes.
13.3.7.1 Adding RF ID Codes
To add RF ID codes into the system, press [1] when “Add RF ID? Press
1.” scrolls across the display. Figure 45 illustrates what appears on the
display.
To add the location shown in Figure 45 as an RF device to the system
(Location 9 is used as an example), press [9] followed by [*]. The RF ID
code appears as shown in Figure 46.
Enter the nine-digit ID code found on the back of the RF device and then
press [Cmd]. “ID added. Press Cmd.” appears on the second line of the
display, indicating the code was successfully entered and accepted. Press
[Cmd].
If an error message appears, make sure you enter the code as printed on
the back of the device and that you only enter nine digits.
Press [Cmd]. The display returns to the first location designated as an RF device and scrolls through other RF device
locations (if any). You may enter the desired location number and add the ID code as described above.
When all RF ID codes have been entered, press [Cmd] once. The first line of the display shows “Configuring RF Please Wait.”
During this period, the RF Receiver’s LED blinks approximately once every second until all ID bytes have been recognized. If
the devices are successfully configured, the display returns to the scrolling RF Menu.
If an error message appears, make sure the RF Receiver’s transmit lines are properly connected to the D6412/D4412 and no
shorted conditions are present.
From the RF Menu, you may choose 1 to enter additional RF ID codes or you may select one of the other RF Menu choices.
When you have finished with the RF Menu, press [Cmd] to return to the main programming menu.
• Locations 41 to 44: RF Keypads (four maximum; one per location)
• Locations 45 to 76: RF Keyfobs
3.3.7.2 Testing RF Devices
To test RF devices that have been added to the system, press [2] when
Test RF Devices? Press 2 scrolls across the display. Figure
47 shows what the appears in the display.
The display scrolls through all properly configured devices and asks if
you want to test. Using Location 9 as an example (as shown in Figure
47), press [9] followed by [*] to test the RF device at Location 9. The
first line of the display shows Activate device!, indicating the
device must be activated in order to test it. Once the device is activated,
the display shown in Figure 48 appears:
Loc9 A1 Pt9
To add push 9*.
Key sequence to press
Point
NumberAreaLocation
Figure 45: Adding RF ID Codes Menu Display
Figure 46: RF ID Code Display
Loc9 A1 Pt9
Test? Press 9*.
Point
Number
Area
Location
Key sequence to press
Figure 47: Test RF Devices Display
Figure 48: RF Device Test Status Display
To Next Page
Loading...
