Bosch GCM 8S Professional - Technical Data and Compliance; Noise, Vibration, and Safety Data; Saw Blade Specifications

English | 37
Bosch Power Tools 1 619 P03 475 | (10/4/08)
57 Allen screw (size 3 mm) for standard bevel
angle 0° (vertical)
58 Allen screw (size 3 mm) for standard bevel
angle 45° (vertical)
59 Recessed grips
60 Caps for carbon brushes
61 Carbon brushes
*The accessories illustrated or described are not in-
cluded as standard delivery.
Technical Data
Noise/Vibration Information
Measured values determined according to
EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 98 dB(A);
Sound power level 111 dB(A). Uncertainty
K=3dB.
Wear hearing protection!
The hand-arm acceleration is typically below
2.5 m/s
2
.
Declaration of Conformity
We declare under our sole responsibility that
the product described under “Technical Data” is
in conformity with the following standards or
standardization documents: EN 61029,
EN 60825-1 according to the provisions of the
directives 2004/108/EC, 98/37/EC (until Dec.
28, 2009), 2006/42/EG (from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
D-70745 Leinfelden-Echterdingen
11.04.2008, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Sliding Mitre Saw GCM 8 S
Professional
Article number
3 601 L16 0..
Rated power input
W1400
Rated voltage
V230
Frequency
Hz 50/60
No-load speed
rpm 5000
Laser type
650 nm, < 1mW
Laser class
2
Weight according to
EPTA-Procedure
01/2003
kg 15
Protection class
/II
Maximum workpiece dimensions, see page 42.
Starting cycles generate brief voltage drops. Interfer-
ence with other equipment/machines may occur in
case of unfavourable mains system conditions. Mal-
functions are not to be expected for system impedanc-
es below 0,24 ohm.
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dimension of suitable saw blades
Saw blade diameter
mm 210–216
Blade thickness
mm 1.5–2.8
Saw blade mounting
hole
mm 30
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-198-003.book Page 37 Thursday, April 10, 2008 2:56 PM