Bosch GCM 8S Professional - Ceiling Strip Sawing (US Standard); US Standard Ceiling Strip Settings

44 | English
1 619 P03 475 | (10/4/08) Bosch Power Tools
Ceiling Strips/Mouldings (According to US Standard)
When the ceiling strips/mouldings are to be sawn lying flat on the saw table, the
standard mitre angles of 31.6° (horizontal) and 33.9° (vertical) must be set.
The following table contains instructions for sawing ceiling strips/mouldings.
Settings Placed
against
the fence
Lying flat
on the saw
table
Vertical bevel angle 0° 33,9°
Ceiling strip/moulding
Left side Right side Left side Right side
Inner corner Horizontal mitre
angle
45° right 45° left 31.6° right 31.6° left
Positioning of
workpiece
Bottom edge
against the
fence
Bottom edge
against the
fence
Upper edge
against the
fence
Bottom edge
against the
fence
The finished
workpiece is lo-
cated...
... to the right
of the cut
... to the left of
the cut
... to the left of
the cut
... to the left of
the cut
Outer cor-
ner
Horizontal mitre
angle
45° left 45° right 31.6° left 31.6° right
Positioning of
workpiece
Bottom edge
against the
fence
Bottom edge
against the
fence
Bottom edge
against the
fence
Upper edge
against the
fence
The finished
workpiece is lo-
cated...
... to the right
of the cut
... to the left of
the cut
... to the right
of the cut
... to the right
of the cut
52°
38°
52°
OBJ_BUCH-198-003.book Page 44 Thursday, April 10, 2008 2:56 PM