tion to be locked out, allowing for micro-
adjustments to any miter angle.
12. Miter Lock Knob – The miter lock knob
locks the miter saw table at any desired
miter angle.
13. Miter Detent Lever – The lever releases
the table from the detent.
14. Bevel Lock Lever – The front-positioned
bevel lock lever locks the head assembly at
the desired bevel angle.
15. Miter Scale/Miter Pointer – The pointer
rotates with the table and blade. It points
to the miter scale to indicate the angle set-
ting before a cut is made.
16. Miter Detent Plate – The position of the
plate can be adjusted to set the accuracy
of its detent locations.
17. Miter Detents – There are ten (10) miter
detent slots for fast and accurate miter
cuts of common miter angles.
18. Table – Provides workpiece support, ro-
tates for desired miter cuts and rotates the
head assembly. The front extended part of
the table is called the miter arm.
19. Base – Provides working surface to sup-
port workpiece.
20. Tool Mounting Pads – The four corners of
the saw provide areas to clamp, bolt or nail
the saw to a flat work surface.
21. Base Extension Clamping Levers – Lock
To Next Page
Loading...
