14
Getting To Know Your Miter Saw
the base extensions at the desired posi-
tions.
22. Sliding Base Extensions – Provide extra
work support. Useful when cutting long
workpieces.
23. Rubber Deflector – Attaches to bottom of
chute. Deflects dust into the chute.
24. Dust Chute – Directs sawdust up and
through the elbow and to the bag.
25. Elbow – Connects the dust chute to the
dust bag. Can be rotated to direct dust.
26. Dust Bag – Has a zipper at the bottom.
Bag can be uncoupled from elbow for emp-
tying.
27. Mechanism Lock Lever – Holds saw in full
back position for chop cuts or fully ex-
tended for transporting.
28. Link Knob – Attaches guard link to the
pivot post.
29. Lower Guard Link – Allows for smooth
movement of the lower guard.
30. Clamp – Use to hold the workpiece to the
table and base – insert into clamp post lo-
cation (item 39).
31. Connectivity Module Compartment –
Bosch Connectivity Module is used to con-
nect the tool to Bosch Toolbox app on a
mobile device.
32. Depth Stop Screw – Turn the knob end to
adjust the blade depth for cutting grooves.
33. Depth Stop Plate – Plate can be swung
out to limit the depth of the blade travel.
34. Pivot Post – Provides support for the saw
head, dust collection system and other
functional parts.
35. Axial Glide Mechanism – Allows saw to
smoothly slide in and out. Can be locked
in full rear or fully extended positions.
36. Bevel Scale and Pointers – Scale is large
and angled - allows user to easily read
bevel angles. Pointer indicates what the
current angle is.
37. Bevel Post – Provides rotating support for
all miter saw parts above the table.
38. Bevel Detent Pin (Crown Molding Set-
ting) – When engaged, it locks the head as-
sembly to the bevel angle of 33.9° to the
left or right.
39. Clamp Post Locations – Two vertical post
holes in the base – provided to insert the
clamp (item 30).
40. Miter Detent Plate Screws – Four screws
accessible through holes in the miter
scale. These screws are loosened when ad-
justing position of the detent plate.
41. Bevel Range Selector Knob – Allows se-
lection of 3 bevel ranges: “0-45° Left”, “0-
45° Right” or “Max. Bevel Angle to 47°.”
42. Arbor Lock – Press arbor lock button to
keep blade from rotating when loosening
or tightening arbor bolt during blade re-
moval or installation.
43. Head Assembly Lock Pin – Used to lock
the head assembly in the lower position
for transporting.
44. Glide Movement Controller – Adjusts to
regulate movement of the glide mecha-
nism.
45. Mounting Holes for Optional Crown Stop
or Length Stop.
46. Battery Bay – used to insert Bosch battery
packs.
47. Battery Pack (sold separately)
48. Battery Pack Release button – used to re-
move battery pack from the battery bay.
49. Cast-in Carry Handles – Used for lifting
and transporting of saw.
50. User Interface – used to select the preset
speed levels and to indicate the status of
the power tool and battery.
51. Set Screws for Laser Line Guide – used to
adjust the laser line guides.
To Next Page
Loading...
