AII repairs, electrical or mechani-
cal, should be attempted only by
trained repairmen. Contact the nearest Factory
Service Center or Authorized Service Station or
other competent repair service. Use only identical
replacement parts, any other may create a hazard.
LUBRICATION
The gear case has been completely lubricated at the
factory. However, after six months to one year, de-
pending upon use, it's wise to return your tool to the
nearest Service Center for the following:
Brushes replaced.
Parts cleaned and inspected.
Relubricated with fresh lubricant.
Electrical system tested.
• All repairs.
The following parts should be oiled occasionally with
SAE No. 20 or No. 30 oil, or WD 40 (Fig. 60).
1. Elevation, support rods, and gears.
2. Sliding rails and supports.
3. Table locking cams (Front & Rear).
RecommendedAccessories
Item Cat. No. Item Cat. No.
Dust bag TS1004 Pusher Guide System TS1010
Zero Clearance Insert TS1012 Table Saw Stand GTA500
Dado Insert Set TS1013
Use only recommended accessories. Follow instructions that accompany accessories.
Use of improper accessories may cause hazards.
-35-
To Next Page
Loading...
