-17-
Tools Needed For Assembly
Combination Square
Flat screwdriver
Phillips screwdriver
Fig. 5
Combination square must be true.
Draw light line
on board along
this edge.
Straight edge of
board 3/4” (19
mm) thick. This
edge must be
perfectly straight.
There should be no gap or
overlap here when square is
flipped over in dotted position.
Fig. 6
1609B07947GTS18V-08 OSI 08-2022.indd 17 8/3/22 2:44 PM
To Next Page
Loading...
