-2-
The definitions below describe the level of severity for each signal word.
Please read the manual and pay attention to these symbols.
!
This is the safety alert symbol. It is used to alert you to potential per-
sonal injury hazards. Obey all safety messages that follow this symbol
to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
Table of Contents
Safety Symbols
Safety Symbols ......................2
General Power Tool Safety Warnings .....3
Safety Instructions for Table Saws .......5
Additional Safety Rules................9
Intended Use .......................9
Specifications ......................10
Cutting Capacities ..................10
Symbols ..........................11
Getting to Know Your GTS18V-08
Table Saw ......................13
Glossary ..........................15
Unpacking and Checking Contents......16
Unpacking the Table Saw ..........16
Tools Needed For Assembly ...........17
Assembly..........................18
Inserting and Releasing the
Battery Pack .................18
Removing and Installing the Table
Insert .......................18
Attaching the Smart Guard System...19
Selecting and Changing the Blade ...21
Attaching the Rip Fence ...........22
Storage, Transportation, and
Mounting.......................26
Miter Gauge Storage ..............26
Push Stick Storage ...............26
Rip Fence Storage ................26
Smart Guard System Storage .......27
Hex Wrench Storage ..............30
Blade Wrench Storage.............30
Transporting the Saw .............31
Mounting the Table Saw ...........32
Adjustments .......................33
Adjusting the Blade Parallel to
the Miter Gauge Slots ..........33
Rip Fence Adjustments ............34
Riving Knife Alignment ............37
Adjusting the Table Insert ..........39
Adjusting 0° and 45° Positive
Stops .......................39
Basic Table Saw Operations ...........41
Power Switch ...................41
Fuel Gauge .....................41
Using the Smart Guard System......42
Riving Knife (Splitter) .............42
Barrier Guard Assembly ...........43
Anti-Kickback Device..............43
Making Work Helpers .............43
Using the Push Stick, Push Block,
and Auxiliary Fence ............47
1609B07947GTS18V-08 OSI 08-2022.indd 2 8/3/22 2:44 PM
To Next Page
Loading...
