Bosch MKK-040 - Removal and Replacement; 14�1 Removing the Cable Channel; 14�2 Removing the Switches

48/62 Bosch Rexroth AG Linear modules MKK/MKR-xxx-NN-3 | R320103169/2020-08
14 Removal and replacement
To ensure the accuracy of the product after replacement of assemblies (e.g.toothed belt, ball guide rail, carriage,
frame, BASA, etc.), such assemblies may only be removed and replaced by BoschRexroth. The only exceptions to
this rule are the work steps described in this section.
14.1 Removing the cable channel
Fig�45: Removing the cable channel
1. Widen the end of the cable duct using ascrewdriver.
2. Lift and swivel out the cover strip.
3. Remove the cables.
4. Screw out the fastening screws.
5. Push the cable duct out of the recess of the profiled support using ascrewdriver.
14.2 Removing the switches
CAUTION
Risk of electrical shocks due to contact with live parts(24 V)!
Risk of minor injuries.
f Before commencing work on any switches, switch off the power supply and secure it against reactivation.
The cables are molded into the proximity switches. If necessary, we recommend arepurchase.
X Disassemble the switches in the reverse order as during assembly
! 6.5
1. 2. 5.