Bosch MKK-040 - 14�3 Removing the Drive

ENGLISH
7
8
R320103169/2020-08 | Linear modules MKK/MKR-xxx-NN-3 Bosch Rexroth AG 49/62
14.3 Removing the drive
WARNING
Risk of product crashing down in vertical or slanting installations due to lack of arrestor devices!
Death or severe injury.
f If the product is installed vertically or on aslant, secure the product against dropping before loosening the
mounting screws.
f Do not stand in the fall direction of the product.
Risk of electric shock due to contact with live parts!
Death or severe injury.
f Before working on the electrical equipment, switch off the power supply and secure it against being switched
on again.
14.3.1 Removing the motor (MKK flange/coupling)
1. Loosen the fastening screws on the motor end (8) at the coupling. If necessary, release the motor brake and
move the carriage so that the drive journal turns.
2. Loosen the motor-side mounting screws (7) and remove the motor from the flange.
Fig�46: Disassembling the motor