Bosch MKK-040 - Page 5

ENGLISH
R320103169/2020-08 | Linear modules MKK/MKR-xxx-NN-3 Bosch Rexroth AG 5/62
Safety instructions are structured as follows:
SIGNAL WORD
Type of hazard!
Consequences if ignored.
f Hazard prevention measure.
• Warning sign: draws attention to the hazard
• Signal word: indicates the severity of the hazard
• Type of hazard: indicates the type or source of hazard
• Consequences: describes the consequences that may occur if precautions to avoid the hazard are not taken
• Hazard prevention measure: indicates how to avoid the hazard
The safety instructions cover the following hazard classes. The hazard class describes the risks involved if the
safety instruction is not complied with.
Table 2: Hazard classes as per ANSI Z535
Warning sign, signal word Meaning
DANGER
Indicates ahazardous situation which will result in death or serious injury if not avoided.
WARNING
Indicates ahazardous situation which may result in death or serious injury if not avoided.
CAUTION
Indicates ahazardous situation which may result in minor or moderate injury if not avoided.
NOTE
Property damage: The product or surroundings may be damaged
1.3.2 Symbols
The following symbols indicate notes which are not related to safety but make the documentation easier to
understand.
Table 3: Meaning of the symbols
Symbol Meaning
If this information is not observed, the product will not be optimally used / operated.
X
Single, independent work step
1.
2.
3.
Numbered work steps
The numbers indicate the sequence of the work steps.
! 7
See section 7
!  Fig. 7.1
See figure 7.1
Screw with strength class...
u
Tightening torque
m
Friction factor for screws