38 en | Camera set-up FlexiDome IP Camera
AR18-10-B006 | v1.1 | 2010.06 Installation and Operation Manual Bosch Security Systems
6.2 Install menu
When the Install menu is opened, the MAC address of the unit
is shown. This is factory set and cannot be changed. (To ensure
that the correct MAC address is displayed, wait 20 seconds
after power-up before opening the Install menu.)
The items in the Install menu include the Mode selection, the
Lens Wizard submenu, the Network submenu, and the Defaults
submenu.
Note:
Camera parameter set-up is done via IP. See
Section 9.6 Camera for the specific camera menus.
To Next Page
Loading...
