Pack201 | Maintenance | Section 6
EN | 12
© Bosch Packaging Technology, Inc.
All rights reserved 2012
6.4.3 Monthly Maintenance Checklist
Monthly Maintenance Checks
Assembly Maintenance Check
Infeed Chain Check for stress and wear.
Backstand Check the brake pressure and the clamping force of the cone
and adjust if necessary.
Make sure all bearings turn freely
Finseal Clean the slip rings and check them for wear.
Replace the carbon brushes if needed.
Crimpers Clean the gear wheels on the crimper shafts and apply grease
if needed.
Check the shaft bearings for play.
Clean the slip rings and check them for wear.
Replace the carbon brushes if needed.
6.4.4 Annual Maintenance Checklist
Annual Maintenance Checks
Assembly Maintenance Check
Geared belts and chains Replace all geared belts and chains every year.
Bearings Replace bearings at least every two years, depending on wear.
To Next Page
Loading...