Pack201 | Maintenance | Section 6
EN | 11
© Bosch Packaging Technology, Inc.
All rights reserved 2012
Discharge Conveyor Section
Assembly Maintenance Check
Conveyor Inspect for proper alignment and transfer from cutting head.
Belt tracking Inspect and adjust tension.
Bearings and wear components Inspect and lubricate.
Monitoring devices. Check for proper setup and operation.
Drive Section
Assembly Maintenance Check
Mechanical components,
sprockets, torque limiters
Inspect for wear
Gear boxes Check for leaks. Check oil level and refill if necessary.
Bearings Check and lubricate. Perform oil change on machines with oil
bath.
Motors, encoders and cables Inspect for damage and for tight connections.
Electrical Section
Assembly Maintenance Check
Terminals and components Inspect for damage and tight connections. Power down before
handling electrical components!
Voltage Check incoming voltage. Tune the voltage on power supplies if
necessary.
Servo drives Check settings and tune if necessary.
Electrical enclosure Inspect and clean as needed.
To Next Page
Loading...