Pack201 | Maintenance | Section 6
EN | 10
© Bosch Packaging Technology, Inc.
All rights reserved 2012
Finwheel Section
Assembly Maintenance Check
Finwheel covers Inspect for excessive wear. Replace if necessary.
Finwheels Inspect for proper opening and closing.
Inspect for proper pitch (carbon paper may be used).
Solenoids Inspect and adjust for proper operation and pressure.
Tilting mechanism Inspect for proper operation and tilt.
Housing assembly Lubricate if the unit is not sealed.
Air flow regulators Inspect and adjust if necessary.
Deckplates Inspect and clean as needed.
Heat elements Inspect for wear and proper operation
Heater wiring and thermocouple Inspect for chafing and tight connection
Collector ring assembly Check components for wear and alignment.
Vacuum tube Inspect and adjust for proper fit.
Cutting Head Section
Assembly Maintenance Check
Mechanical drive components
and sprockets or gears
Inspect for wear.
Chain Inspect for stretch and wear. Check chain tension
Shafts Inspect for excessive endplay.
Cutting head Check hight adjustment in relation to product being run
(product spacer diameter).
Knife and anvil Inspect for wear and proper operation. Replace if necessary.
Apply a thin coat of lubricant.
Shaft Inspect and adjust phasing.
Crimper Inspect adn adjust alignment, clearance and pressure.
Bearings and related
components.
Lubricate.
Heat elements Inspect for wear and proper operation.
Heater wiring and thermocouple Inspect for chafing and tight connections.
Collector ring assembly Check components for wear and alignment.
Temperature controllers Autotune
To Next Page
Loading...