Pack201 | Maintenance | Section 6
EN | 9
© Bosch Packaging Technology, Inc.
All rights reserved 2012
Infeed Section
Assembly Maintenance Check
Chain Remove and clean using a soap solution. Lightly lubricate
chains and chain guides.
Check flight length/package length ratio.
Inspect for wear and proper tension.
Pushers and pins Inspect for wear and condition.
Drive Sprockets and drive
mechanisms.
Inspect for wear
Gear box Inspect for leaks
Product Guides Inspect and adjust for optimum product flow. Replace broken
knobs.
Bearings Inspect for wear. Replace if necessary.
Proximity switch Inspect for function and proper setup.
WARNING
When the chain or chains are
adjusted, avoid excessive tension.
If they are too tight, it will cause
premature wear on the sprockets
and chain.
Backstand Section
Assembly Maintenance Check
Rollers Clean all rollers and related components. Check for wear and
free rotation.
Main Spindles Inspect for wear and condition.
Bearings Inspect for wear and condition. Lubricate.
Power feed roll Inspect for wear, proper setup and operaton.
Gear box Inspect for leaks.
Splicer Inspect for wear and proper setup.
Dancer arm Inspect for proper operation.
Monitoring devices Check for proper setup and operation.
Pressure Roller Check operation. Adjust by turning the shaft if necessary.
Former Section
Assembly Maintenance Check
Former Inspect for proper sizing to product. Check for proper
mounting and wear. Check for proper height, centerline, and
angle position.
Wings, mount block, and
associated components.
Clean as needed. Check for sharp edges and smooth if
necessary.
To Next Page
Loading...