Pack201 | Maintenance | Section 6
EN | 8
© Bosch Packaging Technology, Inc.
All rights reserved 2012
6.4 Maintenance
To prevent malfunctions and damage to the
wrapper, check the equipment for correct
reassembly and for tools, supplies etc. left
lying in or on the machine.
DANGER
Whenever maintaining this
equipment, always lockout the
main power source with the
disconnect lever on the wrapper
per OSHA Standard 1910.147.
This precaution must be taken to
avoid the possibility of a serious
shock hazard, or an accidental
cycling of the wrapper which could
cause a very serious injury. It is
recommended the air supply also
be disconnected before starting.
6.4.1 Daily Maintenance Checklist
Daily Maintenance Checks
Assembly Cleaning Procedure
Former/Folding Box Check bearing operation.
Discharge Belt Check belt tension. Adjust if necessary.
6.4.2 Weekly Maintenance Checklist
General
Assembly Maintenance Check
Film splicer Inspect for proper operation
Reject systems Check for proper setup and operation
Product flow Ensure proper flow through the machine. Record all settings
and adjustments.
Safety Components
Assembly Maintenance Check
E-Stop switches Inspect for proper operation
Interlock Switches and Safety
Devices
Inspect for proper operation
Machine Guard Inspect for proper installation and function.
Warning labels Inspect and replace if missing or damaged
To Next Page
Loading...