Pack201 | Operator Instructions | Section 3
EN | 14
© Bosch Packaging Technology, Inc.
All rights reserved 2012
Endseal/Crimpers
If the new product size requires a change of crimpers:
1� Remove the crimper that is NOT the main crimper
from the top and bottom shafts�
2� Bolt the new crimper(s) to the appropriate posi-
tions on the top and bottom shafts�
3� Replace the product spacers between the crimpers
if needed�
4� Adjust the cutting head height if needed�
Product Spacer
Crimpers
To Next Page
Loading...