Pack201 | Operator Interface | Section 4
EN | 47
© Bosch Packaging Technology, Inc.
All rights reserved 2012
PARAMETER DEFINITION
Home Rate (ppm) This is the desired speed in packages per minute that the wrapper will
run during the homing sequence�
Hot Shoe Enable In the ON position the hot shoe option is active� In the OFF position the
option is disabled�
Hot Shoe Off Delay This is the distance in lm travel that the hot shoe will remain operating
after a No Product No Paper condition is detected�
Hot Shoe On Delay This is the distance in lm travel that the hot shoe will remain open
after a No Product No Paper condition is cleared�
Infeed Pitch (pitches) This is the number of chain pitches between every two pushers on an
infeed chain�
Infeed Reject Enable In the ON position the infeed reject eye is active� In the OFF position the
reject eye is disabled�
Jam Eye Delay (sec) This is how long the machine waits when the jam eye is blocked before
the machine stops�
Jog Rate (ppm) This is the desired wrapper speed in packages per minute while the
machine is in jog mode�
Lineshaft X Enable In the ON position the lineshaft axis is active� In the OFF position the
axis is disabled�
Lineshaft X Linear Offset This is a correction that may be added to change the position of the
device being driven by the lineshaft�
Lineshaft X Rotary Offset This is a correction that may be added to change the position of the
device being driven by the lineshaft�
Lineshaft X Rotary Ratio
(Cycles/Product)
This is the number of cycles the lineshaft driven device must turn for
each product�
Long Product # To Reject This is the desired number of packages to reject when a long product is
detected�
Long Product Reject (on/off) In the ON position the long product reject eye is active� In the OFF posi-
tion the reject eye is disabled�
Long Product Reject Shifts This is the number of cycles from the long product reject eye to the
reject device�
LPF/Sweep Chain Pitches This is the number of inches between chain pushers times 2�
LPF/Sweep Offset This is a value that can be added to change the placement of the prod-
uct in the infeed conveyor ight.
LPF/Sweep Ratio This is the ratio of LPF or Sweep products to wrapper infeed chain
ights.
Master Phase This is a signal from a device that allows the wrapper to be timed to the
device�
Maximum Missed Registration This is the maximum number of consecutive registration marks not de-
tected before the wrapper will stop�
Melted Film # To Reject (prod) This is the desired number of packages to reject when a melted package
is detected�
Melted Film Reject Enable In the ON position the melted lm reject is active. In the OFF position
the reject is disabled�
To Next Page
Loading...