Pack201 | Operator Interface | Section 4
EN | 51
© Bosch Packaging Technology, Inc.
All rights reserved 2012
PARAMETER DEFINITION
Sync # To Reject This is the desired number of packages to reject during a synchroniza-
tion cycle�
Sync Reject Enable In the ON position the sync reject system is active� In the OFF position
the reject is disabled�
Tucker Enable In the ON position the tucker option is active� In the OFF position the
option is disabled�
Uncut # To Reject (prod) This is the desired number of packages to reject when an uncut package
is detected�
Uncut Reject Enable In the ON position the uncut reject eye is active� In the OFF position the
reject eye is disabled�
Uncut Reject Shifts (prod) This is the number of cycles from the uncut reject eye to the reject de-
vice�
Units/Product Lineshaft X This is the number of units (mm, chain pitches) the lineshaft driven
device must move for each product�
To Next Page
Loading...